Filter Assembly Adhesives

End capping compounds, panel sealants and assembly adhesives are provided in urethane and epoxy technologies. Gases, fuels, oils and water are routinely filtered by products built with Key Polymer filter adhesives, end cap molding materials and sealants.

Low-cost Foam

We have hard piped and installed pumps for each one of our 27 bulk storage tanks. Each tank is piped to each of our 13 production vessels.

Fast Molding

Flexible and rigid molded end cap materials. Custom colors and de-mold times. Incinerate-able filters without expensive metal parts.

No Mix One-Part

Room temperature-stable and heat activated. Stable as dispensed. Media is repositionable until heated plate sets adhesive. Invertible grades available to assemble both endcaps at once!

Side Seams & Tin Plate

Side seams, controlled lateral flow down the pleat but no seepage through the media.

Soak & Succeed

Key Polymer understands your elevated temperature immersion performance needs. Talk to filter assembly specialists about your problem fluids.

• Key Polymer provided filter end cap molding material customized to corporate colors to reinforce the customer’s brand identity.
• Cartridge filter side seam sealing adhesive was optimized for faster lateral flow down the seam while maintaining the necessary anti-wicking properties to prevent drain out into the filter media.
• Key Polymer focused on the specific requirements of a HEPA filters sealant for specialized electronics clean room applications which will not outgas either in production or during its life cycle.
• Key Polymer’s ability and ready willingness to customize enabled a filter producer to meet increased demand without capital outlay by providing an end capping system that cured three times faster. The addition of one operator to the existing operator tripled production, with no increase in materials cost!